2024-07-23

Switch - Window - Front - RH (Remove and Install)

Correction code 1513047091 1513047092 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the RH front door and lower the RH front window.
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Install).
  3. Disconnect MV power. See Mid-Voltage Power (Disconnect and Connect) (Modify).
  4. Remove the RH front door beltline assembly. See Beltline Assembly - Door Panel - Front - LH (Remove and Install).
  5. Remove the RH front door trim panel. See Panel - Door Trim - Front - LH (Remove and Install).
  6. Remove the RH front door trim panel NVH foam. See NVH Foam - Door - Front - LH (Remove and Install).
  7. Disconnect the RH front window switch electrical connector, and then release the tabs (x4) that attach the switch to the trim panel assembly.

Install

  1. Position the RH window switch to the door trim panel, connect the electrical connector, and then engage the tabs (x4) that attach the switch to the door trim panel.
  2. Install the RH front door trim panel NVH foam. See NVH Foam - Door - Front - LH (Remove and Install).
  3. Install the RH front door trim panel. See Panel - Door Trim - Front - LH (Remove and Install).
  4. Install the RH front door beltline assembly. See Beltline Assembly - Door Panel - Front - LH (Remove and Install).
  5. Reconnect MV power. See Mid-Voltage Power (Disconnect and Connect) (Modify).
  6. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Install).
  7. Raise the RH front window and close the RH front door.