Center Console - Back Panel Assembly (Remove and Install)
Correction code 1519023041 1519023042 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Remove
- Open the LH front door and lower the LH front window.
- Move the LH front seat fully forward.
- Open the LH rear door and lower the LH rear window.
-
Release the clips (x10) that attach
the back panel assembly to the center console, and then disconnect the electrical
connectors (x3) and release the harness clips (x3).
-
Remove the screws (x2) that attach the
HV outlet to the center console back panel, release the harness clips (x2), and then
remove the back panel from the vehicle.Tip: Use of the following tool(s) is recommended:
- Torx T20 bit
Install
-
Position the HV outlet to the center
console back panel, install the harness clips (x2), and then install the screws (x2)
that attach the HV outlet to the back panel.Tip: Use of the following tool(s) is recommended:
- Torx T20 bit
-
Position the center console back panel assembly to the center console, connect the
electrical connectors (x3) and secure the harness clips (x3), and then secure the clips
(x10) that attach the back panel to the center console.
Tip: Replace any missing or damaged clips.
- Raise the LH rear window and close the LH rear door.
- Restore the LH front seat back to its original position.
- Raise the LH rear window and close the LH rear door.