2026-08-09

Wiper Blade - Windshield (Remove and Install)

Correction code 1750135041 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Press down on the square locking tab to release the latch, and then slide upwards to release the wiper blade.
  3. Disconnect the wiper blade hose.
  4. Pull the wiper blade upwards to remove it from the vehicle.

Install

  1. Position the wiper blade into the wiper arm, but do not fully install it yet.
  2. Connect the wiper blade hose.
    Note
    Make sure the O-rings are not pinched.
  3. Fully install the wiper blade.
    Note
    Make sure the latch fully engages. Perform a push-pull-push test to confirm.
  4. Raise the LH front window and close the LH front door.