23/07/2024 17:35:38

Undertray - Lower Tub Crossmember Assembly (Remove and Install)

Correction code 1203128021 FRT 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Place the vehicle into Service Mode via the UI. See Service Mode.
  3. Open the powergate.
  4. Open the tailgate.
  5. Open the tonneau cover.
  6. Remove the rear fascia assembly. See Rear Bumper Fascia - Rear Fascia (Remove and Install).
  7. Open the bed cargo tub lid.
  8. Remove the bolts (x4) that attach the bed cargo tub to the vehicle.
    8 Nm (5.9 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  9. Remove the bolts (x2) that attach the lower tub crossmember to the vehicle, and then remove the crossmember from the vehicle.
    20 Nm (14.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 13 mm socket

Install

  1. Position the lower tub crossmember into the vehicle, and then install the bolts (x2) that attach the crossmember to the vehicle.
    20 Nm (14.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 13 mm socket
  2. Install the bolts (x4) that attach the bed cargo tub to the vehicle.
    8 Nm (5.9 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  3. Install the rear fascia assembly. See Rear Bumper Fascia - Rear Fascia (Remove and Install).
  4. Close the tonneau cover.
  5. Close the tailgate.