Rear Bumper Fascia - Body Side Bracket - LH (Remove and Install)
Correction code
1001089041
FRT
0.36
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the rear fascia assembly. See Rear Bumper Fascia - Rear Fascia (Remove and Install).
- Remove the LH rear center step bracket. See Rear Bumper Fascia - Fascia Step Bracket Center - LH (Remove and Install).
-
Remove the fasteners (x3) and clips
(x2) that attach the LH rear body side bracket to the vehicle, and then slide the
bracket rearward to remove it from the vehicle.
6 Nm (4.4 lbs-ft)Tip: Use of the following tool(s) is recommended:- 10 mm socket
Install
-
Position the LH rear body side bracket to the vehicle, and then install the fasteners
(x3) and clips (x2) that attach the bracket to the vehicle.6 Nm (4.4 lbs-ft)Tip: Use of the following tool(s) is recommended:
- 10 mm socket
- Install the LH rear center step bracket. See Rear Bumper Fascia - Fascia Step Bracket Center - LH (Remove and Install).
- Install the rear fascia assembly. See Rear Bumper Fascia - Rear Fascia (Remove and Install).