23/07/2024 17:30:45

Headlamps - Headlamp Assembly - LH (Remove and Install)

Correction code 1740067011 1740067021 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Remove the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  3. Remove the frunk assembly. See Frunk Assembly (Remove and Install).
  4. Remove the front center applique. See Front Grille and Applique - Front Center Applique Assembly (Remove and Install).
  5. Release the connector lock, and then disconnect the LH headlamp harness electrical connector.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not push down on the locking tab. Pull the locking tab once to unlock, and then pull again to disconnect.
  6. Apply masking tape to the top of the LH front fascia under the LH headlight.
  7. Remove the bolts (x2) that attach the LH headlamp assembly to the vehicle, and then remove the headlamp from the vehicle.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Lift the headlamp up slightly, and then pull the headlamp forward to release it from the datum.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pry gently with a trim tool as needed.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the LH headlamp assembly into the vehicle, and then install the bolts (x2) that attach the headlamp to the vehicle.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the datum fully engages.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Remove the masking tape from the front fascia.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure no adhesive residue remains
    Informational PurposesAn informational icon, calling your attention
    Note
    Use IPA wipes to clean the surface if needed.
  3. Connect the LH headlamp harness electrical connector, and then engage the connector lock.
  4. Install the front center applique. See Front Grille and Applique - Front Center Applique Assembly (Remove and Install).
  5. Install the frunk assembly. See Frunk Assembly (Remove and Install).
  6. Install the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  7. Calibrate the headlights. See Headlight - Adjust (Wall Method).