23/07/2024 17:23:36

2nd Row Seat Belts - LH 2nd Row Buckle Mini Anchor (Remove and Install)

Correction code 2005004031 2005004032 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Fold the LH 2nd row seat to the up position.
  3. Push the red release mechanism to release the 2nd row center retractor from the LH 2nd row buckle.
  4. Disconnect the 2nd row LH side buckle electrical connector.
  5. Release the clip that attaches the LH 2nd row buckle anchor harness to the seat frame.
  6. Remove the bolt that attaches the 2nd row LH side buckle anchor to the seat assembly.
    40 Nm (29.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 15 mm socket
  7. Slide the 2nd row LH side buckle anchor upward to clear the frame, and then remove the anchor from the seat assembly.

Install

  1. Position the 2nd row LH side buckle anchor to the seat assembly, and then slide the anchor downward to seat it into the seat assembly.
  2. Install the bolt that attaches the 2nd row LH side buckle anchor to the seat assembly.
    40 Nm (29.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 15 mm socket
  3. Install the clip that attaches the LH 2nd row buckle anchor harness to the seat frame.
  4. Connect the 2nd row LH side buckle electrical connector.
  5. Secure the 2nd row center retractor onto the 2nd LH row buckle.
  6. Restore the LH 2nd row seat to its original position.
  7. Raise the LH front window and close the LH front door.