2024-07-23

Back Lumbar - 2nd Row Seat (Remove and Install)

Correction code 1305003031 1305003032 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH rear door and lower the LH rear window.
  2. Release the clips (x7) and datum that attach the LH 2nd row shoulder cover to the body, and then remove the cover from the vehicle.
  3. Remove the LH 2nd row seat back inboard bolster. See Bolster - Inboard - LH - 2nd Row Seat Back (Remove and Install).
  4. Release the tabs (x4) that attach the 2nd row seat back lumbar to the vehicle, and then remove the lumbar from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Slide the lumbar towards the LH side of vehicle to release it.

Install

  1. Position the 2nd row seat back lumbar into the vehicle, and then slide the lumbar towards the RH side of the vehicle to secure the tabs (x4).
  2. Install the LH 2nd row seat back inboard bolster. See Bolster - Inboard - LH - 2nd Row Seat Back (Remove and Install).
  3. Position the LH 2nd row shoulder cover into the vehicle, and then secure the clips (x7) and datum that attach the LH 2nd row shoulder cover to the body.
  4. Raise the LH rear window and close the LH rear door.