23/07/2024 17:27:29

Dash Support Frame - IP Center Shroud Service Panel (Remove and Install)

Correction code 1405028101 1405028102 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Release the clips (x4) and guide datums (x2) that attach the instrument panel center shroud service panel to the instrument panel, release the connector lock and disconnect the electrical connector, and then remove the service panel from the instrument panel.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pry from the opening slit on either side to release.

Install

  1. Position the instrument panel center shroud service panel to the instrument panel, connect the electrical connector and engage the connector lock, and then secure the clips (x4) and guide datums (x2) that attach the service panel to the instrument panel.
  2. Raise the LH front window and close the LH front door.