Front and Rear Door Seals - Outer Waist Belt Seal, Front Door, LH (Remove and Install)
Correction code
1170042081
FRT
0.06
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Open the LH front door and lower the LH front window.
- Release the clips (x18) that attach the LH front door lower belt line assembly to the vehicle, disconnect the electrical connectors (x2), and then remove assembly from the vehicle.
- Release the rubber datums (x6) to remove the LH front door inner waist belt seal from the door assembly.
- Pull the LH front door outer waist belt seal inward to remove it from the door assembly.
Install
- Position the LH front door outer waist belt seal onto the LH front door, and then press the seal firmly into the door assembly.
- Install the LH front door inner waist belt seal into the door assembly.
-
Position the LH front door lower belt line assembly into the vehicle, connect the
electrical connectors (x2), and then secure the clips (x18) that attach the assembly to
the vehicle.
NoteReplace any missing or damaged clips.
- Raise the LH front window and close the LH front door.