2025-05-27

Quarter Panel Assembly - LH - Instrument Panel (Remove and Replace)

Correction code 1405027052 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2025-03-13: Updated removal steps and added videos. Panel must be broken and discarded. Updated procedure title to Remove and Replace.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Remove LH IP quarter panel
    Informational PurposesAn informational icon, calling your attention
    Note
    3x large clips, 3x small clips, 2x datums, 3x doghouses, Release small inner clips then locate doghouses, Break doghouse walls to release from panel, Remove panel then remove doghouses and clips, Protect IP as needed, If IP is damaged then proceed to replacement, Panel is single use, Discard after removal

Install

  1. Install LH IP quarter panel
    Informational PurposesAn informational icon, calling your attention
    Note
    3x large clips, 3x small clips, 2x datums, 3x doghouses, Position then secure clips, If IP is damaged then proceed to replacement, Panel is single use, Install new panel
  2. Raise the LH front window and close the LH front door.