29/02/2024 11:32:03

Front Seat Sliders and Controllers - 1R Seat Outboard Riser Cast LH (Remove and Install)

Correction code 1301061101 1301061102 1301061111 1301061112 FRT 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH doors and lower the LH windows.
  2. Remove the LH mid A-pillar trim. See A-B-C Positivet Interior Trim - A-Pillar Mid Trim - LH (Remove and Install).
  3. Remove the LH lower A-pillar trim. See A-B-C Positivet Interior Trim - A-Pillar Lower Trim - LH (Remove and Install).
  4. Remove the LH 1st row seat assembly. See Front Seat Assemblies - 1st Row Seat Assembly - LH Drive - LH - Black (Remove and Install).
  5. Remove and discard the bolt that attaches the LH front seat crossmember to the outboard riser.
    35 Nm (25.8 lbs-ft)
    Tip: 13 mm socket
  6. Remove the LH 1st row outboard riser bolt cover. See Front Seat Covers and Pads - 1R Seat Screw Cover LH (Remove and Install).
  7. Remove and discard the bolts (x2) that attach the LH 1st row seat outboard riser to the vehicle, and then remove the riser from the vehicle.
    40 Nm (29.5 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Slide the riser forward, and then lift to clear the crossmember assembly.
    Tip: Use of the following tool(s) is recommended:
    • 13 mm socket

Install

  1. Position the LH 1st row seat outboard riser into the vehicle, and then install new bolts (x2) that attach the riser to the vehicle.
    40 Nm (29.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 13 mm socket
  2. Install the LH 1st row outboard riser bolt cover. See Front Seat Covers and Pads - 1R Seat Screw Cover LH (Remove and Install).
  3. Install a new bolt that attaches the LH front seat crossmember to the outboard riser.
    35 Nm (25.8 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 13 mm socket
  4. Install the LH 1st row seat assembly. See Front Seat Assemblies - 1st Row Seat Assembly - LH Drive - LH - Black (Remove and Install).
  5. Install the LH lower A-pillar trim. See A-B-C Positivet Interior Trim - A-Pillar Lower Trim - LH (Remove and Install).
  6. Install the LH mid A-pillar trim. See A-B-C Positivet Interior Trim - A-Pillar Mid Trim - LH (Remove and Install).
  7. Restore the LH front seat back to its original position.
  8. Raise the LH front window and close the LH front door.