2024-07-23

Passenger Ducting and Vents - IP Floor Duct LH Inboard (Remove and Install)

Correction code 1810084041 1810084042 FRT 0.54 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the lower instrument panel assembly. See Dash Panel - Instrument Panel Lower Assembly (Remove and Install).
  2. Remove the glovebox assembly. See Dash Panel - IP Glovebox Assembly (Remove and Install).
  3. Remove the RH air wave duct. See Passenger Ducting and Vents - Panel Duct, RH (Remove and Install).
  4. Remove the front passenger airbag. See Front Air Bags - MX - Passenger Airbag, NAR (Remove and Install).
  5. Remove the instrument panel top pad assembly. See Dash Panel - Instrument Panel Top Pad Assembly (Remove and Install).
  6. Remove the LH IP quarter panel. See Dash Panel - Quarter Panel Assembly - LH (Remove and Replace).
  7. Remove the LH quarter glass demist duct. See Passenger Ducting and Vents - Quarter Glass Demist Duct, LH (Remove and Install).
  8. Remove the LH instrument panel floor duct outboard. See Interior Ducting and Vents - Instrument Panel Floor Duct Outboard - LH (Remove and Install).
  9. Remove the LH inboard IP floor duct from the HVAC case.

Install

  1. Install the LH inboard IP floor duct onto the HVAC case.
  2. Install the LH instrument panel floor duct outboard. See Interior Ducting and Vents - Instrument Panel Floor Duct Outboard - LH (Remove and Install).
  3. Install the LH quarter glass demist duct. See Passenger Ducting and Vents - Quarter Glass Demist Duct, LH (Remove and Install).
  4. Install the LH IP quarter panel. See Dash Panel - Quarter Panel Assembly - LH (Remove and Replace).
  5. Install the instrument panel top pad assembly. See Dash Panel - Instrument Panel Top Pad Assembly (Remove and Install).
  6. Install the front passenger airbag. See Front Air Bags - MX - Passenger Airbag, NAR (Remove and Install).
  7. Install the RH air wave duct. See Passenger Ducting and Vents - Panel Duct, RH (Remove and Install).
  8. Install the glovebox assembly. See Dash Panel - IP Glovebox Assembly (Remove and Install).
  9. Install the lower instrument panel assembly. See Dash Panel - Instrument Panel Lower Assembly (Remove and Install).