10/12/2024 14:46:30

Rear Door Trim Pad - Beltline Assembly - LH (Remove and Replace)

Correction code 1513091082 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-12-10: Update RGB address routine steps from Toolbox to vehicle UI.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Install

  1. Install the LH rear door beltline assembly. See Rear Door Trim Pad - Beltline Assembly - LH (Remove and Install).
  2. Place the vehicle into Service Mode. See Service Mode.
  3. Unlock the vehicle Gateway. See Gateway (Unlock).
  4. On the vehicle touchscreen, navigate to Service Mode > Mid Voltage > Interior Lighting > Address RGB Lights, tap Run, and allow the routine to complete.
    Informational PurposesAn informational icon, calling your attention
    Note
    Verify that the vehicle firmware is version 2024.44 or later.
    Informational PurposesAn informational icon, calling your attention
    Note
    Close the routine once complete.
  5. Exit Service Mode. See Service Mode.
  6. Raise the LH front window and close the LH front door.