23/07/2024 17:28:53

Front and Rear Door Seals - Secondary Seal, Front Door, LH (Remove and Install)

Correction code 1170042031 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door.
  2. Release the clips (x26) that attach the LH front door secondary seal to the door assembly, and then remove the seal from the vehicle.

Install

  1. Position the LH front door secondary seal to the door assembly, and then secure the clips (x26) that attach the seal to the door.
    Informational PurposesAn informational icon, calling your attention
    Note
    Installation begins with the orange clip on the outer edge of the door. There is a slit for the latch screws.
  2. Close the LH front door.