2026-08-09

Access Panel - Frunk (Remove and Install)

Correction code 1224057051 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2024-08-05: Added note for newer versions of the access panels.
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Open the powered frunk.
  3. Release the clips (x7) that attach the frunk access panel to the underhood storage unit, and then remove the access panel from the underhood storage unit.
    Note
    Early versions of the access panel have hand access pockets at the bottom to aid in removing panel. Newer versions do not 't have these hand access pockets. For newer versions, use a pry tool on the upper edge to remove the panel.
    Figure 1. Older version with access pockets at the bottom
    Figure 2. New version without access pockets; use pry tool to release from upper edge

Install

  1. Position the frunk access panel into the underhood storage unit, and then secure the clips (x7) that attach the access panel to the underhood storage unit.
    Note
    Replace any missing or damaged clips.
  2. Close the powered frunk.
  3. Raise the LH front window and close the LH front door.