2026-10-30

Trailer Connection Socket (Remove and Replace)

Correction code 17030100001 17030100002 0.00 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.
  • 2026-10-14: Released new procedure.

Remove

  1. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  2. Remove the rear fascia. See Rear Fascia (Remove and Install).
  3. Disconnect the trailer connector socket, and then release the clips (x2) and remove the socket from the vehicle.
    Note
    Depress the tabs to release connector socket.

Install

  1. Position the trailer connector socket into the vehicle, connect the electrical connector, and then firmly press the socket into the vehicle to seat the clips (x2).
  2. Install the rear fascia. See Rear Fascia (Remove and Install).
  3. Remove the vehicle from the lift. See Raise Vehicle - 2 Post Lift.