23/07/2024 17:32:11

License Plate Mounting - Front License Plate Assembly (Remove and Install)

Correction code 1207080011 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the screws (x4) that attach the front license plate to the license plate bracket, and then remove the license from the bracket.
    1 Nm (.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Phillips PH2
  2. Remove the screws (x3) that attach the front license plate bracket to the vehicle, and then remove the bracket from the vehicle.
    1 Nm (.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Phillips PH2

Install

  1. Position the front license plate bracket onto the vehicle, and then install the screws (x3) that attach the bracket to the vehicle.
    1 Nm (.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Phillips PH2
  2. Position the license plate onto the license plate bracket, and then install the screws (x4) that attach the license plate to the bracket.
    1 Nm (.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Phillips PH2