23/07/2024 17:33:54

Seat Track Position Sensor - 1R Seat Track Position Sensor (Remove and Install)

Correction code 2020107011 2020107012 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Move the LH front seat fully forward.
  3. Disconnect the LH seat track position sensor electrical connector, remove the screw that attaches the sensor to the seat assembly, and then remove the sensor from the vehicle.
    2 Nm (1.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket

Install

  1. Position the LH seat track position sensor into the seat assembly, connect the electrical connector, and then install the screw that attaches the sensor to the seat assembly.
    2 Nm (1.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket
  2. Restore the LH front seat back to its original position.
  3. Raise the LH front window and close the LH front door.