Tonneau - Manual Release, Tailgate (Remove and Install)
Correction code
1120122081
FRT
0.18
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the tailgate inner cover. See Truck Bed - Tailgate Inner Cover (Remove and Install).
-
Release the latching bracket and cable
stay to release the LH manual release cable. Repeat this step for the RH manual release
cable.
NoteRelease latch on bracket, then slide inboard to release. Pivot the cable stay 90 degrees to release it from the latch.
- Release the clips (x2) and latching bracket that attach the tailgate manual release cable assembly to the vehicle, and then slide the cable upward to remove the assembly from the vehicle.
Install
- Position the tailgate manual release cable assembly into the vehicle, and then secure the clips (x2) and latching bracket that attach the assembly to the vehicle.
- Maneuver the LH manual release cable into position, install the cable stay to the latch, and then secure the latching bracket. Repeat this step for the RH manual release cable.
- Install the tailgate inner cover. See Truck Bed - Tailgate Inner Cover (Remove and Install)