23/07/2024 17:30:43

Ground Strap Cable - Rear Drive Unit (Tri Motor) (Remove and Replace)

Correction code 4001093122 FRT 0.66 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  3. Remove the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  4. Disconnect MV power. See Disconnect MV Power.
  5. Remove the mid aeroshield. See Undertray - Mid Aeroshield (Remove and Install).
  6. Remove the rear aeroshield. See Undertray - Rear Aeroshield (Remove and Install).
  7. Remove the rear diffuser. See Undertray - Diffuser (Remove and Install).
  8. Remove the bolts (x2) that attach the RDU ground strap to the vehicle, and then remove the ground strap from the vehicle.
    10 Nm (7.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the RDU ground strap into the vehicle, and then install the bolts (x2) that attach the ground strap to the vehicle.
    10 Nm (7.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Install the rear diffuser. See Undertray - Diffuser (Remove and Install).
  3. Install the rear aeroshield. See Undertray - Rear Aeroshield (Remove and Install).
  4. Install the mid aeroshield. See Undertray - Mid Aeroshield (Remove and Install).
  5. Reconnect MV power. See Disconnect MV Power.
  6. Install the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  7. Remove the vehicle from the lift. See Raise Vehicle - 2 Post Lift.
  8. Raise the LH front window and close the LH front door.