2026-06-17

Foam - Seat Back - 1st Row Seat - LH (with Ventilation) (Remove and Replace)

Correction code 1307060122 FRT 0.66 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-06-17: Released new procedure.

Install

  1. Install the 1st row LH seatback heat pad.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    The foam and heat pad cannot be reused.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Position the pad onto the foam, then remove the adhesive backing. Ensure that the pad is fitted into the foam channels.
    Figure 1. Position the pad, then remove the adhesive backing.
    Figure 2. Adhere the heat pad in the highlighted areas.
  2. Install the 1st row LH seatback foam onto the seatback frame.
  3. Install the 1st row LH seatback trim. See Trim - Seat Back - 1st Row - LH (Remove and Install).