2024-07-23
Front and Rear Door Seals - Inner Waist Belt Seal, Front Door, LH (Remove and Install)
Correction code
1170042011
1170042012
1170042021
1170042022
FRT
0.06
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Warning
This procedure is a DRAFT.
Although it has been validated, Warnings and Cautions might be missing. Follow safety
requirements and use extreme caution when working on or near High Voltage systems and
components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
Remove
- Open the LH front door and lower the LH front window.
- Remove the LH front door beltline assembly. See Front Door Trim Pad - Beltline Assembly - LH (Remove and Install).
-
Release the rubber datums (x6) that
attach the LH front inner waist belt seal to the door assembly, and then remove the seal
from the vehicle.
Install
-
Position the LH front inner waist belt
seal to the door assembly, and then secure the rubber datums (x6) that attach the seal
to the door.
- Install the LH front door beltline assembly. See Front Door Trim Pad - Beltline Assembly - LH (Remove and Install).
- Raise the LH front window and close the LH front door.