23/07/2024 17:34:00

Side and A-Pillar Harnesses - Harness - Roof Accessory Jumper (Remove and Install)

Correction code 1710109051 1710109052 FRT 0.71 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Open the RH front door and lower the RH front window.
  3. Open the RH rear door.
  4. Remove the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  5. Disconnect MV power. See Disconnect MV Power.
  6. Remove the RH B-pillar applique closeout. See Exterior Trim Fittings - Closeout - LH (Remove and Install).
  7. Remove the RH B-pillar applique. See Exterior Trim Fittings - B-Pillar Applique - LH (Remove and Install).
  8. Remove the RH roof applique. See Exterior Trim Fittings - Roof Applique - LH (Remove and Install).
  9. Release the connector lock, and then disconnect the roof accessory jumper harness electrical connector in the B-pillar.
  10. Release the clip and grommet that attaches the roof accessory jumper harness to the vehicle, and then remove the harness from the vehicle.

Install

  1. Position the roof accessory jumper harness into the vehicle, and then secure the clip and grommet that attaches the harness to the vehicle.
  2. Connect the roof accesssory jumper harness electrical connector in the B-pillar, and then engage the connector lock.
  3. Install the RH roof applique. See Exterior Trim Fittings - Roof Applique - LH (Remove and Install).
  4. Install the RH B-pillar applique. See Exterior Trim Fittings - B-Pillar Applique - LH (Remove and Install).
  5. Install the RH B-pillar applique closeout. See Exterior Trim Fittings - Closeout - LH (Remove and Install).
  6. Reconnect MV power. See Disconnect MV Power.
  7. Install the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  8. Raise all the windows and close all the doors.