23/07/2024 17:32:07

Latch - Powergate (Remove and Install)

Correction code 1133116101 0.24 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Remove the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  3. Remove the frunk assembly. See Frunk Assembly (Remove and Install).
  4. Apply paint mark around the edges of the powergate latch to mark the current position.
  5. Remove the bolts (x2) that attach the powergate latch to the vehicle.
    9 Nm (6.6 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  6. Disconnect the powergate latch electrical connector, and then release the clip that attaches the connector to the vehicle.
  7. Release the clips (x2) and cables (x2) that attach the powergate latch to the vehicle, and then remove the latch from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Turn the latch assembly over for access to the cable stays.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pinch the sides of the LH cable stay, and then pull outward to release it.
    Informational PurposesAn informational icon, calling your attention
    Note
    Depress the tab on the RH cable stay, and then slide outward to release it.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the cable ends from the grooves.

Install

  1. Release the clips (x2) and cables (x2) that attach the powergate latch to the vehicle, and then remove the latch from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Secure the cable ends to the latch assembly, and then secure the cable stays.
    Informational PurposesAn informational icon, calling your attention
    Note
    If replacing the latch assembly, add correction code as required for panel adjustment.
  2. Connect the powergate latch electrical connector, and then secure the connector to the vehicle.
  3. Align the latch assembly with the bolt witness marks, and then install the bolts (x2) that attach the powergate latch to the vehicle.
    9 Nm (6.6 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  4. Install the frunk assembly. See Frunk Assembly (Remove and Install).
  5. Install the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  6. Raise the LH front window and close the LH front door.