23/07/2024 17:32:09

Latch - Powergate (Remove and Replace)

Correction code 1133116101 1133116102 FRT 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Remove the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  3. Remove the frunk assembly. See Frunk Assembly (Remove and Install).
  4. Mark the position of the latch.
    Informational PurposesAn informational icon, calling your attention
    Note
    Apply paint mark around edges of the latch for proper positioning of the new latch.
  5. Disconnect the powergate latch electrical connector, and then release the connector from the latch assembly.
  6. Remove the bolts (x2) that attach the powergate latch to the vehicle.
    9 Nm (6.6 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  7. Release cables (x2) and clip from the powergate latch, and then remove the latch assembly from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Rotate the latch assembly for access to the cable stays.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pinch the sides of the LH cable stay, and then pull the cable outward to release it. Press the tab on the RH cable stay, and then slide the cable outward to release it.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the cable ends from the grooves.

Install

  1. Position the powergate latch into the vehicle, and then secure the cables (x2) and clip to the latch assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Secure the cable ends to the latch assembly, and then secure the cable stays.
  2. Align the powergate latch with the bolt witness marks, and then install the bolts (x2) that attach the latch to the vehicle.
    9 Nm (6.6 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  3. Connect the powergate latch electrical connector, and then secure the connector to the latch assembly.
  4. Close the powergate and check gap and flush measurements. Adjust as necessary.
    Informational PurposesAn informational icon, calling your attention
    Note
    Refer to CVIS for gap and flush tolerances. Add correction code as required for panel adjustment.
  5. Install the frunk assembly. See Frunk Assembly (Remove and Install).
  6. Install the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  7. Raise the LH rear window and close the LH rear door.