Secondary Seal - Rear Door - LH (Remove and Install)
Correction code
1170042101
FRT
0.06
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy
working practices.
Remove
- Open the LH rear door.
-
Starting from the outer edge of the LH
rear door, release the clips (x16) that attach the LH rear door secondary seal to the
door assembly, and then remove the seal from the door assembly.
CAUTIONUse trim pry tool to prevent clips from breaking into the door.
Install
-
Position the LH rear door secondary
seal onto the LH rear door, and then install the clips (x16) that attach the seal to the
door assembly.
NoteThe different color pin should be install on the outer edge of the door assembly.
- Close the LH rear door.