2026-08-09

Foam Seal - Side - Front Grille (Remove and Install)

Correction code 1001052061 FRT 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Remove the front lower fascia. See Front Fascia (Remove and Install).
  2. Remove and discard the side foam seal.
    Note
    Adhesive may tear off from the foam.
    Note
    Remove any remaining adhesive.
    Note
    Wipe the area with IPA wipes.

Install

  1. Peel the adhesive backing off of the new foam seal, and then install the foam seal onto the grille.
    Note
    Make sure the foam is aligned with the upper and lower foam seams.
    Note
    Wet out the adhesive with a roller.
  2. Install the front lower fascia. See Front Fascia (Remove and Install).