Puddle Lamp - Door Panel - Rear - LH (Remove and Install)
Correction code
1513091021
1513091022
FRT
0.06
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy
working practices.
Remove
- Open the LH rear door and lower the LH rear window.
-
Release the LH rear puddle lamp from
the LH rear door trim, disconnect the electrical connector, and then remove the puddle
lamp from the vehicle.
Install
-
Position the LH rear puddle lamp to the LH rear door trim, connect the electrical
connector, and then secure the puddle lamp to the door trim.
- Raise the LH rear window and close the LH rear door.