23/07/2024 17:33:03

Rear Door Trim Pad - Window Switch (Remove and Install)

Correction code 1513091071 1513091072 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH rear door and lower the LH rear window.
  2. Remove the LH rear beltline assembly. See Rear Door Trim Pad - Beltline Assembly - LH (Remove and Install).
  3. Remove the LH rear door trim. See Rear Door Trim Pad - Door Trim Rear - LH (Remove and Install).
  4. Remove the LH rear door trim NVH foam from the door trim.
    Informational PurposesAn informational icon, calling your attention
    Note
    Lift the NVH foam off of the retaining tabs (x3).
  5. Release the LH rear door trim window switch from the door trim, disconnect the electrical connector, and then remove the switch from the door trim.
    Informational PurposesAn informational icon, calling your attention
    Note
    Press the 2 accessible tabs, and then gently pry the switch assembly out of the housing.
    Informational PurposesAn informational icon, calling your attention
    Note
    The switch assembly must be replaced if any tabs break during removal.

Install

  1. Position the LH rear door trim window switch to the door trim, connect the electrical connector, and then engage the tabs (x4).
    Informational PurposesAn informational icon, calling your attention
    Note
    The switch assembly must be replaced if any tabs break during removal.
  2. Position the LH rear door trim NVH foam onto the door trim, and then secure the foam onto the retaining tabs (x3).
  3. Install the LH rear door trim. See Rear Door Trim Pad - Door Trim Rear - LH (Remove and Install).
  4. Install the LH rear beltline assembly. See Rear Door Trim Pad - Beltline Assembly - LH (Remove and Install).
  5. Raise the LH front window and close the LH front door.