23/07/2024 17:28:17

Exterior Trim Fittings - Lightbar Beauty Cover - LH (Remove and Install)

Correction code 1220035181 1220035182 1220035191 1220035192 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the powered frunk.
  2. Remove the push clips (x2) and push pin that attach the LH lightbar beauty cover to the vehicle, and then remove the cover from the vehicle.

Install

  1. Position the LH lightbar beauty cover into the vehicle, and then install the push clips (x2) and push pin that attach the cover to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Replace any missing or damaged clips.
  2. Close the powered frunk.