2026-08-09

Bracket - License Plate - Front (Retrofit)

Correction code 12070106 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Install

  1. Remove the front license plate dummy cover. See Front License Plate Dummy Cover.
  2. Position the front license plate bracket onto the vehicle, and then install the screws (x3) that attach the bracket to the vehicle.
    1 Nm (.7 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Phillips PH2
  3. Position the license plate onto the license plate bracket, and then install the screws (x4) that attach the license plate to the bracket.
    1 Nm (.7 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Phillips PH2