26/03/2024 10:07:26

A-B-C Positivet Interior Trim - B-Pillar Lower Trim - LH (Remove and Install)

Correction code 1518006011 1518006012 1518006061 1518006062 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Open the LH rear door and lower the LH rear window.
  3. Fold the LH 2nd row seat the up position.
  4. Partially release the LH rear primary door seal.
  5. Release the clip and datum that attach the front portion of the LH lower C-pillar trim.
  6. Remove the LH mid A-pillar trim. See A-B-C Positivet Interior Trim - A-Pillar Mid Trim - LH (Remove and Install).
  7. Remove the LH lower A-pillar trim. See A-B-C Positivet Interior Trim - A-Pillar Lower Trim - LH (Remove and Install).
  8. Move the LH front seat fully forward.
  9. Starting from the lower rear section of the LH lower B-pillar trim, release the clips (x11), datums (x4), and seal retainers (x4) that attach the trim to the B-pillar.

Install

  1. Position the LH lower B-pillar trim into the vehicle, and then secure the clips (x11), datums (x4), and seal retainers (x4) that attach the trim to the B-pillar.
  2. Secure the clip and datum that attach the front portion of the LH lower C-pillar trim.
  3. Secure the LH rear primary door seal.
  4. Return the LH 2nd row seat to the original position.
  5. Raise the LH rear window and close the LH rear door.
  6. Restore the LH front seat back to its original position.
  7. Install the LH lower A-pillar trim. See A-B-C Positivet Interior Trim - A-Pillar Lower Trim - LH (Remove and Install).
  8. Install the LH mid A-pillar trim. See A-B-C Positivet Interior Trim - A-Pillar Mid Trim - LH (Remove and Install).
  9. Raise the LH front window and close the LH front door.