Center Console - Wireless Charger Gen 5.0 (Remove and Replace)
Correction code 1519023122 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
- 2024-05-13: Removed Toolbox steps and added steps to reinstall software.
Remove
- Remove the LH center floor rail. See Passenger Compartment Carpet - Center Floor Rail - LH (Remove and Install).
- Remove the center console front panel assembly. See Center Console - Front Panel Assembly (Remove and Install).
-
Disconnect the electrical connector
and release the harness clip, remove the screws (x4) that attach the wireless charger to
the center console, and then remove the charger from the vehicle.Tip: Use of the following tool(s) is recommended:
- Torx T20 socket
Install
-
Position the wireless charger to the center console, install the screws (x4) that
attach the charger go the center console, and then connect the electrical connector and
secure the harness clip.Tip: Use of the following tool(s) is recommended:
- Torx T20 socket
- On the vehicle touchscreen, navigate to .
-
Tap the Reinstall button at the "Software Reinstall" dialogue
box.
NoteReinstall will begin immediately.NoteOnce the software redeploy is complete, verify the release notes are present.
- Install the center console front panel assembly. See Center Console - Front Panel Assembly (Remove and Install).
- Install the LH center floor rail. See Passenger Compartment Carpet - Center Floor Rail - LH (Remove and Install).
- Restore the LH front seat back to its original position.
- Raise the LH front window and close the LH front door.