23/07/2024 17:32:21

Passenger Compartment Carpet - Center Floor Trim (Remove and Install)

Correction code 1530083011 1530083012 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the front doors and lower the front windows.
  2. Move the LH and RH front seats fully rearward.
  3. Remove the LH and RH center floor rails. See Passenger Compartment Carpet - Center Floor Rail - LH (Remove and Install).
  4. Release the clips (x4) and datums (x3) that attach the center floor trim to the vehicle, and then remove the trim from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the upper section first.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Avoid bending the trim beyond what is necessary for clearance.
    Informational PurposesAn informational icon, calling your attention
    Note
    Some vehicles may be equipped a 2-piece trim. The 2-piece trim is attached to the vehicle with 17 clips.
    Figure 1. Upper portion of 2-piece trim
    Figure 2. Upper portion of 2-piece trim
    Figure 3. Lower portion of 2-piece trim
    Figure 4. Lower portion of 2-piece trim

Install

  1. Position the center floor trim into the vehicle, and then secure the clips (x4) and datums (x3) that attach the trim to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Position the lower section first, and then secure the upper section.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Avoid bending the trim beyond what is necessary for clearance.
    Informational PurposesAn informational icon, calling your attention
    Note
    Some vehicles may be equipped a 2-piece trim. The 2-piece trim is attached to the vehicle with 17 clips.
    Figure 5. Lower portion of 2-piece trim
    Figure 6. Lower portion of 2-piece trim
    Figure 7. Upper portion of 2-piece trim
    Figure 8. Upper portion of 2-piece trim
  2. Install the LH and RH center floor rails. See Passenger Compartment Carpet - Center Floor Rail - LH (Remove and Install).
  3. Restore the LH and RH front seats back to their original position.
  4. Raise the front windows and close the front doors.