23/07/2024 17:25:34
Audio Speakers - 200mm, Woofer, LH, C-Pillar, Audio (Remove and Install)
Correction code 2121012081 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
Remove
- Open all the doors and lower all the windows.
- Remove the rear lower wall trim. See Passenger Compartment Carpet - End Item, Rear Wall Lower Trim, Soft Trim (Remove and Install).
-
Remove the bolts (x2) that attach the
LH subwoofer assembly to the vehicle, slide the subwoofer to the RH side of the vehicle
to release it, release the connector lock and disconnect the electrical connector, and
then remove the subwoofer from the vehicle.TIpUse of the following tool(s) is recommended:
- 13 mm socket
Install
-
Position the LH subwoofer assembly into the vehicle, slide the subwoofer to the LH
side of the vehicle to secure it, connect the electrical connector and engage the
connector lock, and then install the bolts (x2) that attach the subwoofer to the
vehicle.TIpUse of the following tool(s) is recommended:
- 13 mm socket
- Install the rear lower wall trim. See Passenger Compartment Carpet - End Item, Rear Wall Lower Trim, Soft Trim (Remove and Install).
- Raise all the windows and close all the doors.