Rocker Panel Trim - Rear Rocker Step Reinforcement - LH (Remove and Install)
Correction code
1220105031
1220105032
1220105041
1220105042
FRT
0.24
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the LH rocker assembly. See Rocker Panel Trim - Rocker Assembly - LH (Remove and Install).
-
Remove the bolts (x3) that attach the
LH rear rocker step reinforcement to the vehicle, and then remove the reinforcement from
the vehicle.15 Nm (11.1 lbs-ft)TIpUse of the following tool(s) is recommended:
- 10 mm socket
Install
-
Position the LH rear rocker step reinforcement to the vehicle, and then install the
bolts (x3) that attach the reinforcement to the vehicle.15 Nm (11.1 lbs-ft)TIpUse of the following tool(s) is recommended:
- 10 mm socket
- Install the LH rocker assembly. See Rocker Panel Trim - Rocker Assembly - LH (Remove and Install).