23/07/2024 17:27:31

Dash Support Frame - IP Display Shroud (Remove and Install)

Correction code 1405028091 1405028092 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the RH front door and lower the RH front window.
  2. Release the clips (x4) and guide datums (x2) that attach the instrument panel center shroud service panel to the instrument panel, disconnect the electrical connector, and then remove the service panel from the instrument panel.
  3. Release the connector lock and disconnect the center display electrical connector, remove the bolts (x2) that attach the center display to the vehicle, and then remove the center display assembly from the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Be careful not to stress the harness.
    Informational PurposesAn informational icon, calling your attention
    Note
    Carefully place the center display assembly onto the dash.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  4. Release the clips (x3) that attach the IP display shroud to the center display, and then remove the display shroud from the assembly.
    Tip: Spread the sides first to separate shroud.

Install

  1. Position the IP display shroud to the center display, and then secure the clips (x3) that attach the display shroud to the assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Spread the outer wings and clip the center first to prevent gaps.
  2. Position the center display assembly to the vehicle, connect the center display electrical connector and secure the connector lock, and then install the bolts (x2) that attach the center display to the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  3. Position the instrument panel center shroud service panel to the instrument panel, connect the electrical connector, and then secure the clips (x4) and guide datums (x2) that attach the service panel to the instrument panel.
  4. Raise the LH front window and close the LH front door.