2026-08-09

Sensor - Ride Height - Rear - LH (Remove and Install)

Correction code 3110069031 3110069032 FRT 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2024-09-26: Updated ride height calibration steps.
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  3. Remove the LH rear wheel. See Wheel Assembly (Remove and Install).
  4. Disconnect the LH rear ride height sensor electrical connector.
  5. Remove the nut that attaches the LH rear ride height sensor assembly to the vehicle, and then remove the sensor from the vehicle.
    350 Nm (258.1 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 27 mm socket

Install

  1. Position the LH rear ride height sensor assembly to the vehicle, and then install the nut that attaches the sensor to the vehicle.
    350 Nm (258.1 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 27 mm socket
  2. Connect the LH rear ride height sensor electrical connector.
  3. Install the LH rear wheel. See Wheel Assembly (Remove and Install).
  4. Remove the vehicle from the lift. See Raise Vehicle - 2 Post Lift.
  5. Calibrate the vehicle ride height. See Ride Height Calibration.
  6. Exit Service Mode. See Service Mode.
  7. Raise the LH front window and close the LH front door.