2026-08-09

Link - Stabilizer Bar - Rear - LH (Remove and Install)

Correction code 3103098011 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Remove the LH rear wheel. See Wheel Assembly (Remove and Install).
  2. Remove and discard the nuts (x2) that attach the LH rear stabilizer bar link to the stabilizer bar and knuckle, and then remove the link from the vehicle.
    45 Nm (33.2 lbs-ft)
    Note
    Pull down on stabilizer bar as needed to remove the link.
    Tip
    Use of the following tool(s) is recommended:
    • 15 mm socket

Install

  1. Position the LH rear stabilizer bar link to the stabilizer bar and knuckle, and then install new nuts (x2) that attach the link to the vehicle.
    45 Nm (33.2 lbs-ft)
    Note
    Pull down on stabilizer bar as needed to install the link.
    Tip
    Use of the following tool(s) is recommended:
    • 15 mm socket
  2. Install the LH rear wheel. See Wheel Assembly (Remove and Install).
  3. Raise the LH front window and close the LH front door.