2026-08-09

Recovery Hook - Pair (Install)

Correction code NA NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Install

  1. Remove the front fascia assembly. See Front Fascia (Remove and Install).
  2. Slide the LH recovery hook toward the subframe to position it into the vehicle, and then install new bolts (x4) that attach the hook to the vehicle. Repeat this step for the RH recovery hook.
    78 Nm (57.5 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 15 mm socket
    Figure 1. LH shown; RH similar
    Figure 2. LH shown; RH similar
    Figure 3. LH shown; RH similar
    Figure 4. LH shown; RH similar
  3. Install the front fascia assembly. See Front Fascia (Remove and Install).