2024-07-23

Tailgate Seals - Tonneau Water Management Seal, LH, Center (Remove and Install)

Correction code 1170117041 1170117042 1170117011 1170117012 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-04-03: Cleaned up topic.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the tailgate.
  2. Open the tonneau cover.
  3. Remove the LH tonneau water management seal.
    Informational PurposesAn informational icon, calling your attention
    Note
    x1 clip
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull away from the rail to release the seal from the groove.

Install

  1. Install the LH tonneau water management seal.
    Informational PurposesAn informational icon, calling your attention
    Note
    x1 clip
    Informational PurposesAn informational icon, calling your attention
    Note
    Push the seal into the rail groove.
  2. Close the tonneau cover.
  3. Close the tailgate.