23/07/2024 17:33:43

Rearview Mirror - Rear View Miror (Remove and Install)

Correction code 1505103041 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Release the clips on the bottom of the rear view mirror stay arm cap to release it from the rear view mirror assembly, and then pivot the cap away from the assembly to remove it.
  3. Remove the screw that attaches the rear view mirror to the vehicle, and then remove the rear view mirror from the vehicle.
    2 Nm (1.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket

Install

  1. Position the rear view mirror into the vehicle, and then install the screw that attaches the rear view mirror to the vehicle.
    2 Nm (1.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket
  2. Position the rear view mirror stay arm cap to the rear view mirror assembly, and then install the cap to the assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Align the top of cover with the mirror, and then engage the lower clips.
  3. Raise the LH front window and close the LH front door.