23/07/2024 17:23:22

2nd Row Seat Back Hardware - 2R Seat A - Rest Cupholder Bezel (Remove and Install)

Correction code 1305003091 1305003092 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH rear door and lower the LH rear window.
  2. Fold the 2nd row armrest assembly down.
  3. Release the clips (x6) that attach the 2nd row armrest cupholder bezel to the armrest assembly, and then remove the bezel from the assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Lift the bezel straight upwards to release clips.

Install

  1. Position the 2nd row armrest cupholder bezel into the armrest assembly, and then push the bezel into the assembly to secure the clips (x6).
  2. Fold the 2nd row armrest assembly to the original position.
  3. Raise the LH rear window and close the LH rear door.