23/07/2024 17:32:24
Passenger Compartment Carpet - End Item, Duct Bezel, Soft Trim (Remove and Install)
Correction code 1530083051 1530083052 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
Remove
- Open the LH front door and lower the LH front window.
- Move the LH front seat fully forward.
- Open the LH rear door and lower the LH rear window.
-
Fold up the LH 2nd row seat.
NotePull the tether to release, and then lift up until the seat cushion is locked in place.
- Remove the 2nd row floor mat.
-
Release the clips (x4) that attach the
LH rear carpet duct bezel to the vehicle, and then remove the bezel from the
vehicle.
Install
-
Position the LH rear carpet duct bezel into the vehicle, and then secure the clips
(x4) that attach the bezel to the vehicle.
NoteReplace any missing or damaged clips.
- Install the 2nd row floor mat.
-
Fold the down LH 2nd row seat.
NotePull the tether to release the seat cushion, and then pivot the seat cushion down until it is locked in place.
- Raise the LH rear window and close the LH rear door.
- Restore the LH front seat back to its original position.
- Raise the LH front window and close the LH front door.