23/07/2024 17:23:32

2nd Row Seat Belts - 2R Center Retractor, Black (Remove and Install)

Correction code 2005004021 2005004022 FRT 0.66 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the LH 2nd row seat back. See 2nd Row Seat Assemblies - 2nd Row Seat Back Assembly - LH (Remove and Install).
  2. Remove the nuts (x2) that attach the 2nd row center upper web guide to the vehicle, and then remove the web guide from the vehicle.
    30 Nm (22.1 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 15 mm socket
  3. Depress the red tab on the lower anchor to release the seatbelt from the latch.
  4. Disconnect the seatbelt latch electrical connector.
  5. Remove and discard the bolt and then release the clip that attaches the 2nd row center retractor to the vehicle.
    40 Nm (29.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 13 mm socket

Install

  1. Position the 2nd row center retractor into the vehicle, secure the clip that attaches the retractor to the vehicle, and then install a new bolt.
    40 Nm (29.5 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Align the clip and datums onto the rear wall.
    Tip: Use of the following tool(s) is recommended:
    • 13 mm socket
  2. Connect the seatbelt latch electrical connector.
  3. Install the seatbelt into the lower anchor.
    Informational PurposesAn informational icon, calling your attention
    Note
    Secure the lower anchor ensuring an audible click is heard.
    Informational PurposesAn informational icon, calling your attention
    Note
    Perform a push-pull-push test to make sure the seatbelt is fully engaged.
  4. Position the 2nd row center upper web guide into the vehicle, and then install the nuts (x2) that attach the web guide to the vehicle.
    30 Nm (22.1 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 15 mm socket
  5. Install the LH 2nd row seat back. See 2nd Row Seat Assemblies - 2nd Row Seat Back Assembly - LH (Remove and Install).