23/07/2024 17:23:52

A-B-C Post Interior Trim - C-Pillar Upper Trim - LH (Remove and Install)

Correction code 1518006071 1518006072 1518006091 1518006092 FRT 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH doors and lower the LH windows.
  2. Remove the front header trim. See Headliner Trim - Front Header Trim (Remove and Install).
  3. Remove the LH mid A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Mid Trim - LH (Remove and Install).
  4. Remove the LH IP quarter panel. See Dash Panel - Quarter Panel Assembly - LH (Remove and Install).
  5. Remove the LH cantrail trim. See Headliner Trim - Cantrail Trim - LH (Remove and Install).
  6. Remove the LH 2nd row seat outboard bolster. See 2nd Row Seat Assemblies - 2R Seat Side Bolster LH (Remove and Install).
  7. Partially release the LH rear primary door seal.
  8. Starting from the LH front door sill, pull the LH lower C-pillar trim upward, and then forward to release the clips (x3), tabs (x7, and datums (x4).
    Informational PurposesAn informational icon, calling your attention
    Note
    Leave the trim attached to the seat belt.
  9. Release the clips (x3) and tabs (x3) that attach the LH C-pillar upper trim to the C-pillar, and then remove the trim from the vehicle.

Install

  1. Position the LH C-pillar upper trim to the C-pillar, and then secure the clips (x3) and tabs (x3) that attach the trim to the C-pillar.
  2. Position the LH lower C-pillar trim into the vehicle, and then secure the clips (x3), tabs (x7), and datums (x4) that attach the trim to the vehicle.
  3. Secure the LH rear primary door seal onto the body.
  4. Install the LH 2nd row seat outboard bolster. See 2nd Row Seat Assemblies - 2R Seat Side Bolster LH (Remove and Install).
  5. Install the LH cantrail trim. See Headliner Trim - Cantrail Trim - LH (Remove and Install).
  6. Install the LH IP quarter panel. See Dash Panel - Quarter Panel Assembly - LH (Remove and Install).
  7. Install the LH mid A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Mid Trim - LH (Remove and Install).
  8. Install the front header trim. See Headliner Trim - Front Header Trim (Remove and Install).
  9. Raise the LH windows and close the LH doors.