23/07/2024 17:28:03

Electromechanical Brake Booster - Brake Remote Reservoir (Remove and Install)

Correction code 3320033021 3320033022 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  2. Remove the frunk assembly. See Frunk Assembly (Remove and Install).
  3. Remove the brake fluid reservoir cap, and then use a brake fluid extractor to remove the brake fluid from the reservoir.
  4. Remove the bolt that attaches the brake fluid reservoir to the vehicle, and then lift the reservoir upwards to release the datum.
    8 Nm (5.9 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  5. Push the yellow tab on the brake fluid tube to release it from the reservoir, and then remove the reservoir from the vehicle.

Install

  1. Position the brake fluid reservoir into the vehicle, and then connect the brake fluid tube to the reservoir.
    Informational PurposesAn informational icon, calling your attention
    Note
    Perform a push-pull-push test to enure the tube is fully engaged.
  2. Align the datum and slide the brake fluid reservoir downwards to engage, and then install the bolt that attaches the reservoir to the vehicle.
    8 Nm (5.9 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  3. Top off brake fluid reservoir.
    Informational PurposesAn informational icon, calling your attention
    Note
    Fill the reservoir to the MAX line.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use only DOT 4 brake fluid.
  4. Install the frunk assembly. See Frunk Assembly (Remove and Install).
  5. Install the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).