Bolster - Inboard - LH - 2nd Row Seat Back (Remove and Install)
Correction code
1305002031
1305002032
1305002041
1305002042
FRT
0.06
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy
working practices.
Remove
- Open the LH front door and lower the LH front window.
-
Release the clips (x4) and datums (x2)
that attach the LH 2nd row seat back inboard bolster to the seat assembly, and then
remove the bolster from the seat assembly.
Install
-
Position the LH 2nd row seat back
inboard bolster into the seat assembly, and then secure the clips (x4) and datums (x2)
that attach the bolster to the seat assembly.
- Raise the LH front window and close the LH front door.