2025-02-21

Bed Side Applique Corner Bracket - RH (Remove and Install)

Correction code 1010025171, 1010025172 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Informational PurposesAn informational icon, calling your attention
Note
This procedure is for vehicles built after November 4th, 2024 with the new version of the sail applique.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Remove the RH sail applique. See Sail Applique - RH (Remove and Install) (Post 11/4/2024).
  2. Remove the bolt that attaches the RH sail applique corner bracket to the vehicle, and then remove the bracket from the vehicle.
    9 Nm (6.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the RH sail applique corner bracket into the vehicle, and then install the bolt that attaches the bracket to the vehicle.
    9 Nm (6.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Align the datum onto the tonneau rail.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Install the RH sail applique. See Sail Applique - RH (Remove and Install) (Post 11/4/2024).